1. INSTALL COMBINATION METER ASSEMBLY

(a) Connect the connector.

(b) Attach the 2 clips.

(c) Install the combination meter with the 2 screws.

2. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Attach the 5 claws to install the register.

3. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Attach the 4 claws to install the register.

4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

(a) Connect the connectors.

(b) Attach the 4 claws to install the finish panel.

(c) Attach the 6 claws.

5. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

(a) Connect the connector.

(b) Attach the 8 claws to install the instrument panel pad.

6. INSTALL NO. 1 SWITCH HOLE BASE

(a) Connect the connectors.

(b) Attach the 5 claws to install the hole base.

7. INSTALL INSTRUMENT SIDE PANEL LH

(a) Attach the 6 claws to install the side panel.

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL