| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Audio/Visual/Telematics | Section: Park Assist/Monitoring | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003E9Z000X |
| Title: PARK ASSIST / MONITORING: CLEARANCE WARNING BUZZER: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
3. REMOVE INSTRUMENT SIDE PANEL LH
4. REMOVE NO. 1 SWITCH HOLE BASE
5. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
7. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
8. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
9. REMOVE NO. 1 CLEARANCE WARNING BUZZER
(a) Disconnect the connector.
(b) Using a clip remover, detach the clip and remove the No. 1 clearance warning buzzer.
|
|