Home › Audio/Visual/Telematics › Park Assist/Monitoring › ULTRASONIC SENSOR (for Front)
Last Modified: 11-27-2007 1.6 A
Service Category: Audio/Visual/Telematics Section: Park Assist/Monitoring
Model Year: 2008 Model: LX570 Doc ID: RM000003EA3000X
Title: PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Front): REMOVAL (2008 LX570)

REMOVAL

1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL (2008 LX570)+

2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL (2008 LX570)+

3. REMOVE ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

4. REMOVE ENGINE ROOM SIDE COVER RH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

5. REMOVE UPPER RADIATOR SUPPORT SEAL EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

6. REMOVE RADIATOR GRILLE ASSEMBLY EXTERIOR PANELS / TRIM: RADIATOR GRILLE: REMOVAL (2008 LX570)+

7. REMOVE FRONT BUMPER COVER EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL (2008 LX570)+

8. REMOVE NO. 4 ENGINE ROOM WIRE EXTERIOR PANELS / TRIM: FRONT BUMPER: DISASSEMBLY (2008 LX570)+

9. REMOVE NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure to remove the No. 1 ultrasonic sensor on the other side.

(a) While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

HINT:

The type of claw on the top and the type of claw on the bottom of the sensor are different. Observe the claws carefully before removing the sensor.

10. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

HINT:

Use the same procedure to remove the No. 1 ultrasonic sensor retainer on the other side.

(a) Detach the 2 claws and remove the ultrasonic sensor retainer from the front bumper cover.