THERMOSTAT > INSTALLATION

1. INSTALL THERMOSTAT

2. INSTALL WATER INLET

3. INSTALL WATER INLET PIPE

4. INSTALL W/CONVERTER INVERTER ASSEMBLY

5. INSTALL INVERTER BRACKET NO.4

6. INSTALL ENGINE ROOM RELAY BLOCK ASSEMBLY

7. REMOVE INVERTER COVER

8. CONNECT NO.3 WIRE FRAME

9. CONNECT MG ECU CONNECTOR

10. CONNECT HIGH VOLTAGE CABLE OF FRONT MOTOR

11. CONNECT ENGINE WIRE NO.4

12. CHECK HIGH VOLTAGE CABLE CONNECTION

13. INSTALL INVERTER COVER

14. INSTALL POWER STEERING ECU BRACKET

15. CONNECT WATER HOSE

16. INSTALL INVERTER RESERVE TANK SUB-ASSEMBLY

17. CONNECT ENGINE ROOM WIRE NO.2

18. CONNECT CIRCUIT BREAKER SENSOR NO.1

19. INSTALL POWER STEERING ECU ASSEMBLY

20. INSTALL INVERTER BRACKET NO.5

21. INSTALL AIR CLEANER W/RESONATER

22. INSTALL AIR CLEANER CAP W/INLET

23. INSTALL COOL AIR INTAKE DUCT SEAL

24. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER

25. INSTALL WINDSHIELD WIPER LINK ASSEMBLY

26. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

27. INSTALL FRONT WIPER AND BLADE ASSEMBLY ARM LH

28. INSTALL FRONT WIPER AND BLADE ASSEMBLY ARM RH

29. INSTALL SERVICE PLUG GRIP

30. REMOVE ENGINE ROOM COVER SIDE

31. INSTALL ENGINE ROOM SIDE LH COVER

32. CONNECT BATTERY NEGATIVE CABLE

33. ADD HYBRIT VEHICLE COOLANT

34. ADD ENGINE COOLANT

35. CHECK HYBRID VEHICLE COOLANT LEAKS

36. CHECK FOR ENGINE COOLANT LEAKS

37. PERFORM INITIALIZATION