THERMOSTAT > REMOVAL

1. PRECAUTION

2. REMOVE ENGINE ROOM SIDE LH COVER

3. REMOVE ENGINE ROOM COVER SIDE

4. DRAIN HYBRIT VEHICLE COOLANT

5. DRAIN ENGINE COOLANT

6. DISCONNECT BATTERY NEGATIVE CABLE

7. REMOVE SERVICE PLUG GRIP

8. REMOVE FRONT WIPER AND BLADE ASSEMBLY ARM RH

9. REMOVE FRONT WIPER AND BLADE ASSEMBLY ARM LH

10. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

11. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

12. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER

13. REMOVE COOL AIR INTAKE DUCT SEAL

14. REMOVE AIR CLEANER CAP W/INLET

15. REMOVE AIR CLEANER W/RESONATOR

16. REMOVE POWER STEERING ECU ASSEMBLY

17. DISCONNECT CIRCUIT BREAKER SENSOR NO.1

18. DISCONNECT ENGINE ROOM WIRE NO.2

19. REMOVE INVERTER RESERVE TANK SUB-ASSEMBLY

20. DISCONNECT WATER HOSE

21. DISCONNECT POWER STEERING ECU BRACKET

22. REMOVE INVERTER COVER

23. VERIFY VOLTAGE OF W/CONVERTER INVERTER ASSEMBLY IS 0 V

24. SEPARATE ENGINE WIRE NO.4

25. DISCONNECT HIGHT VOLTAGE CABLE OF FRONT MOTER

26. DISCONNECT MG ECU CONNECTOR

27. DISCONNECT NO.3 WIRE FRAME

28. INSTALL INVERTER COVER

29. SEPARATE ENGINE ROOM RELAY BLOCK ASSEMBLY

30. REMOVE INVERTER BRACKET NO.4

31. REMOVE W/CONVERTER INVERTER ASSEMBLY

32. REMOVE WATER INLET PIPE

33. REMOVE WATER INLET

34. REMOVE THERMOSTAT