REAR TRACTION MOTOR > INSTALLATION

1. INSTALL EXTENSION WIRE ASSEMBLY

2. INSTALL FRONT DIFFERENTIAL SUPPORT ASSEMBLY

3. INSTALL REAR TRACTION W/ TRANSAXLE MOTOR ASSEMBLY

4. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

5. CONNECT NO.3 WIRE FRAME

6. CONNECT PARKING BRAKE CABLE ASSEMBLY NO.3

7. CONNECT PARKING BRAKE CABLE ASSEMBLY NO.2

8. INSTALL REAR DRIVE SHAFT ASSEMBLY LH

9. INSTALL REAR DRIVE SHAFT ASSEMBLY RH

10. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH

11. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 RH

12. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH

13. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 RH

14. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

15. STABILIZE SUSPENSION

16. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH

17. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 RH

18. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH

19. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 RH

20. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

21. CONNECT HEIGHT CONTROL SENSOR

22. INSTALL REAR AXLE SHAFT LH NUT

23. INSTALL REAR AXLE SHAFT RH NUT

24. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

25. INSTALL EXHAUST PIPE ASSEMBLY

26. INSTALL POWER STEERING ECU BRACKET

27. CONNECT INVERTER RESERVE TANK SUB-ASSEMBLY

28. INSTALL POWER STEERING ECU ASSEMBLY

29. INSTALL INVERTER BRACKET NO.5

30. INSTALL REAR WHEELS

31. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

32. CHECK HIGH VOLTAGE CABLE CONNECTION

33. INSTALL SERVICE PLUG GRIP

34. INSTALL ENGINE ROOM SIDE COVER LH

35. ADD AND INSPECT HYBRID TRANSAXLE FLUID

36. INSPECT EXHAUST GAS LEAK

37. HEADLIGHT AIM ONLY

38. PERFORM INITIALIZATION