REAR DRIVE SHAFT > INSTALLATION

1. INSTALL REAR DRIVE SHAFT ASSEMBLY

2. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY

3. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

4. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

5. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

6. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

7. INSTALL REAR DISC

8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

9. INSTALL REAR SPEED SENSOR

10. INSTALL REAR AXLE SHAFT NUT

11. STABILIZE SUSPENSION

12. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

13. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

14. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

15. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3

16. INSTALL REAR WHEEL

17. ADJUST REAR WHEEL ALIGNMENT

18. CHECK SPEED SENSOR SIGNAL