REAR AXLE CARRIER > INSTALLATION

1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY

2. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

3. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

4. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

5. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

6. INSTALL REAR DISC

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

8. INSTALL REAR SPEED SENSOR

9. INSTALL REAR AXLE SHAFT NUT

10. STABILIZE SUSPENSION

11. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

12. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

13. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

14. CONNECT PARKING BRAKE CABLE ASSEMBLY NO.3

15. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

16. REMOVE REAR DISC

17. INSPECT REAR AXLE HUB BEARING LOOSENESS

18. INSPECT REAR AXLE HUB RUNOUT

19. INSTALL REAR DISC

20. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

21. INSTALL REAR AXLE SHAFT NUT

22. INSTALL REAR WHEEL

23. ADJUST REAR WHEEL ALIGNMENT

24. CHECK SPEED SENSOR SIGNAL