FRONT AXLE HUB > INSTALLATION

1. INSTALL FRONT AXLE HUB BEARING

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY

3. INSTALL FRONT DISC BRAKE DUST COVER

4. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

5. INSTALL FRONT AXLE HUB HOLE SNAP RING

6. INSTALL FRONT WHEEL BEARING DUST DEFLECTOR NO.1

7. INSTALL FRONT AXLE ASSEMBLY

8. CONNECT FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1

9. CONNECT TIE ROD ASSEMBLY

10. INSTALL FRONT DISC

11. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

12. INSTALL FRONT SPEED SENSOR

13. INSTALL FRONT AXLE HUB NUT

14. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

15. REMOVE FRONT DISC

16. INSPECT FRONT AXLE HUB BEARING LOOSENESS

17. INSPECT FRONT AXLE HUB RUNOUT

18. INSTALL FRONT DISC

19. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

20. INSTALL FRONT AXLE HUB NUT

21. INSTALL FRONT WHEEL

22. ADJUST FRONT WHEEL ALIGNMENT

23. CHECK SPEED SENSOR SIGNAL