PARKING BRAKE ASSEMBLY > REASSEMBLY

1. INSTALL PARKING BRAKE SHOE LEVER

2. APPLY HIGH TEMPERATURE GREASE

3. INSTALL PARKING BRAKE SHOE HOLD DOWN SPRING NO.1 PIN

4. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

5. INSTALL REAR AXLE SHAFT NUT

6. INSTALL REAR SPEED SENSOR

7. CONNECT PARKING BRAKE NO.3 CABLE ASSEMBLY

8. INSTALL PARKING BRAKE NO.2 SHOE ASSEMBLY

9. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET

10. INSTALL PARKING BRAKE NO.1 SHOE ASSEMBLY

11. INSTALL PARKING BRAKE SHOE STRUT

12. CHECK PARKING BRAKE INSTALLATION

13. INSPECT REAR AXLE HUB BEARING LOOSENESS

14. INSPECT REAR AXLE HUB RUNOUT

15. INSTALL REAR DISC

16. ADJUST PARKING BRAKE SHOE CLEARANCE

17. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

18. INSTALL REAR WHEEL

19. INSPECT PARKING BRAKE PEDAL TRAVEL

20. ADJUST PARKING BRAKE PEDAL TRAVEL

21. CHECK ABS SPEED SENSOR SIGNAL