STEERING COLUMN ASSEMBLY (for Manual Tilt) > REMOVAL

1. PRECAUTION

2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. REMOVE FRONT WHEEL LH

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

5. REMOVE STEERING WHEEL COVER LOWER NO.3

6. REMOVE STEERING WHEEL COVER LOWER NO.2

7. REMOVE STEERING PAD ASSEMBLY

8. REMOVE STEERING WHEEL ASSEMBLY

9. REMOVE FRONT DOOR SCUFF PLATE LH

10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

11. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER

12. REMOVE INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1

13. REMOVE STEERING COLUMN COVER

14. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

15. REMOVE AIR DUCT NO.1

16. SEPARATE STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

17. REMOVE INSTRUMENT PANEL FINISH PLATE

18. REMOVE STEERING COLUMN ASSEMBLY

19. REMOVE STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

20. REMOVE STEERING COLUMN HOLE COVER SUB-ASSEMBLY NO.2

21. REMOVE STEERING SHAFT UNIVERSAL JOINT ASSEMBLY