SKID CONTROL ECU > INSTALLATION

1. INSTALL SKID CONTROL ECU ASSEMBLY

2. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY

3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)

4. INSTALL INSTRUMENT PANEL NO.2 UNDER COVER SUB-ASSEMBLY (for LHD)

5. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (for RHD)

6. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER (for RHD)

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

8. INSTALL FRONT DOOR SCUFF PLATE RH

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. INSPECT SRS WARNING LIGHT

11. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

12. INSPECT VSC WARNING LIGHT

13. PERFORM LINEAR VALVE OFFSET LEARNING

14. CHECK AND CLEAR DTC

15. PERFORM INITIALIZATION