BRAKE PEDAL STROKE SENSOR > INSTALLATION

1. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY (for RHD)

4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

5. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER

6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

8. INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

9. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. CHECK AND CLEAR DTC

12. INSPECT SRS WARNING LIGHT

13. PERFORM LINEAR VALVE OFFSET LEARNING

14. PERFORM INITIALIZATION