RX400h · Service Manual BRAKE

DISASSEMBLY

Removal / installation


1. REMOVE BRAKE TUBE

  1. LHD:

    1. C113651
      Using SST, disconnect the brake tube.
      SST
      09023-00101  

  1. RHD:

    1. C113650
      Using SST, disconnect the brake tube.
      SST
      09023-00101  


2. REMOVE BRAKE MASTER CYLINDER

  1. C111409
    Remove the 2 nuts, 2 brake master cylinder gaskets, brake master cylinder bracket, brake master cylinder and brake stroke simulator bracket.


3. REMOVE MASTER CYLINDER PUSH ROD CLEVIS

  1. Remove the push rod clevis and lock nut.

    HINT:
    Adjustment of brake pedal height is easier when reassembling the brake master w/ simulator cylinder assembly afterward, if the protrusion of the push rod from push rod clevis is measured and recorded at this stage.


4. REMOVE BRAKE STROKE SIMULATOR CYLINDER SUB-ASSEMBLY

  1. C111410
    Disconnect the connector from the bracket.

  1. Remove the 2 bolts and the brake stroke simulator cylinder from the brake stroke simulator bracket.

← REMOVALREASSEMBLY →