ADJUSTMENT
Removal / installation
| 1. ADJUST PARK/NEUTRAL POSITION SWITCH |
Loosen the 2 bolts of park/neutral position switch and set the shift lever to the N position.
Align the protruding part and neutral basic line.
- NOTICE:
- There is play on the nut stopper side (protruding part). Align the center point of the range of the play with the neutral basic line.
Tighten the 2 bolts in the order shown in the illustration.
- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
| 2. INSPECT PARK/NEUTRAL POSITION SWITCH |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
A-1 (D)
A-2 (N)
A-3 (P)
A-4 (R)
A-5 (MJ)
A-6 (FD)
A-7 (B)
A-9 (RV)
P position
10 kΩ or higher
4.2 to 5.1 kΩ
Below 1 Ω
10 kΩ or higher
Below 1 Ω
10 kΩ or higher
10 kΩ or higher
10 kΩ or higher
R position
10 kΩ or higher
4.2 to 5.1 kΩ
10 kΩ or higher
Below 1 Ω
Below 1 Ω
10 kΩ or higher
10 kΩ or higher
Below 1 Ω
N position
10 kΩ or higher
Below 1 Ω
10 kΩ or higher
10 kΩ or higher
Below 1 Ω
10 kΩ or higher
10 kΩ or higher
10 kΩ or higher
D position
Below 1 Ω
4.2 to 5.1 kΩ
10 kΩ or higher
10 kΩ or higher
Below 1 Ω
Below 1 Ω
10 kΩ or higher
B position
10 kΩ or higher
4.2 to 5.1 kΩ
10 kΩ or higher
10 kΩ or higher
Below 1 Ω
Below 1 Ω
Below 1 Ω
10 kΩ or higher