U0001 Following conditions are met for 2 seconds (1 trip detection logic): Engine switch on (IG) Battery voltage is...

DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM (Included in HV Control ECU). The engine control unit intercommunicates with the transmission control ECU with the Controller Area Network (CAN).
If there is a problem in this intercommunication, the ECM sets a DTC.

DTC No.	DTC Detection Condition	Trouble Area
U0001	Following conditions are met for 2 seconds (1 trip detection logic): Engine switch on (IG) Battery voltage is 10.5 V or more No intercommunication between engine control ECU and HV Control ECU	HV Control ECU

INSPECTION PROCEDURE

1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0001)

1. Connect the intelligent tester to the DLC3.

2. Turn the ignition switch ON.

3. Turn the tester ON.

4. Enter the following menus: Powertrain / Engine / DTC.

5. Read DTCs.
   

   Result:

   Display (DTC output)	Proceed to
   U0001	A
   U0001 and other DTCs	B

B	GO TO RELEVANT DTC CHART

A
REPLACE HV CONTROL ECU