RX400h · Service Manual RESTRAINTS

INSTALLATION

Removal / installation


1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

  1. Install the driver side knee airbag assembly with the 4 bolts.

    Torque:
    7.6 N*m{ 78 kgf*cm , 68 in.*lbf }

  1. C111085
    Connect the connector to the driver side knee airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


2. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER

  1. B108587E01
    Connect the connectors.

  1. Engage the 5 claws and the 4 clips.

  1. Connect the hood lock control cable assembly.

  1. Install the bolt <A>, the screw <C>, and the instrument panel finish panel sub-assembly lower.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when disconnecting the cable from the negative battery terminal.


5. INSPECT SRS WARNING LIGHT

  1. Inspect the SRS warning light (Click here).

← REMOVALDISPOSAL →