RX400h · Service Manual RESTRAINTS

REMOVAL

Removal / installation


1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.


3. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER

  1. B108510E02
    Using a screwdriver, open the instrument panel finish panel sub-assembly lower cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt <A> and the screw <C>.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the 5 claws and the 4 clips.

  1. Disconnect the connectors and then remove the instrument panel finish panel sub-assembly lower.


4. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

  1. C111085
    Disconnect the connector from the driver side knee airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the 4 bolts and the driver side knee airbag assembly.

← ON-VEHICLE INSPECTIONINSTALLATION →