RX400h · Service Manual HYBRID SYSTEM

INSPECTION

Inspection


INSPECT IGCT RELAY

  1. Check the resistance.

    1. A032779
      Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      		 Specified Condition
      3 - 5
      		 10 kΩ or higher
      3 - 5
      		 Below 1 Ω
      (when battery voltage is applied between terminals 1 and 2)

      If the result is not as specified, replace the relay.

← INSTALLATIONPRECAUTION →