ON-VEHICLE INSPECTION
Inspection
| INSPECT MAP LIGHT ASSEMBLY |
Remove the map light assembly.
Measure the resistance of the personal light.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
O2-25 (UP) - Body ground
TILT UP
Below 1 Ω
O2-25 (UP) - Body ground
Off
10 kΩ or higher
O2-24 (DOWN) - Body ground
TILT DOWN
Below 1 Ω
O2-24 (DOWN) - Body ground
TILT UP
10 kΩ or higher
O2-10 (OPN) - Body ground
SLIDE OPEN
Below 1 Ω
O2-10 (OPN) - Body ground
TILT UP
10 kΩ or higher
O2-11 (CLS) - Body ground
SLIDE CLOSE
Below 1 Ω
O2-11 (CLS) - Body ground
TILT UP
10 kΩ or higher