RX400h · Service Manual RESTRAINTS

INSTALLATION

Removal / installation


1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

  1. B115713
    Check the degree of tilt when the ELR begins to lock.

    1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt when gently moving the installed retractor.

      NOTICE:
      Do not disassemble the retractor.

  1. B115712
    Temporarily install the front seat outer belt assembly with the 2 bolts.

  1. Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.

    Torque:
    For upper bolt:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }
    For lower bolt:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. B112935
    Connect the tension reducer connector.

  1. Connect the pretensioner connector and lock the locking button.

    NOTICE:
    Securely lock the locking button.

  1. Connect the shoulder side of the front seat outer belt assembly with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


2. INSTALL CENTER PILLAR GARNISH

  1. B110479
    Engage the clip and install the center pillar garnish.

  1. Install the 2 screws.


3. INSTALL CENTER PILLAR GARNISH LOWER

  1. B111788
    Engage the 2 clips and 3 claws, install the center pillar garnish lower.


4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY

  1. Connect the floor side of the front seat outer belt assembly with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Check if the ELR locks.

    NOTICE:
    The check should be performed with the outer belt assembly installed.


    1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.


5. INSTALL LAP BELT OUTER ANCHOR COVER

6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

7. INSTALL REAR DOOR SCUFF PLATE

  1. B111783
    Connect the connector. (w/ illumination scuff plate)

  1. Engage the 4 claws and 2 clips, and install the rear door scuff plate.


8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

9. INSTALL FRONT DOOR SCUFF PLATE

  1. B111782
    Connect the connector. (w/ illumination scuff plate)

  1. Engage the 6 claws and 4 clips, and install the front door scuff plate.


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. PERFORM INITIALIZATION
Some systems need initialization when disconnecting the cable from the negative battery cable (Click here).

12. INSPECT SRS WARNING LIGHT
(Click here)
← REMOVALDISPOSAL →