INSTALLATION

Removal / installation

1. TEMPORARILY TIGHTEN REAR STRUT ROD

1. Install the strut rod (rear side), bolt and nut, and temporarily tighten the bolt.
   

   NOTICE:

   When temporarily tightening the bolt, keep the nut from rotating.

2. Support the rear axle carrier.
   

3. Connect the strut rod (inner side) with the bolt and nut.
   

   NOTICE:

   When temporarily tightening the bolt, keep the nut from rotating.

2. STABILIZE SUSPENSION

1. Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the rear drive shaft assembly is horizontally positioned.
   

3. FULLY TIGHTEN REAR STRUT ROD

1. Fully tighten the bolt.
   

   Torque:

   80 N*m{ 816 kgf*cm , 59 ft.*lbf }

2. Fully tighten the bolt.
   

   Torque:

   80 N*m{ 816 kgf*cm , 59 ft.*lbf }

4. CONNECT PARKING BRAKE NO.3 CABLE ASSEMBLY

1. Install the parking brake cable assembly No.3 with the nut.
   

   Torque:

   6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

5. INSTALL REAR WHEEL

Torque:

103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }