RX400h · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation


1. REMOVE REAR WHEEL

2. REMOVE REAR SUSPENSION NO.2 ARM

  1. C107475E01
    Put matchmarks on the adjust cams and rear suspension member sub-assembly.

  1. Remove the nut, camber adjust cam and toe adjust cam, and disconnect the rear suspension arm No.2 (inner side).

    NOTICE:
    When removing the nut, keep the bolt from rotating.

  1. C109189
    Remove the bolt, nut and the rear suspension arm No.2 (outer side) from the rear axle carrier.

    NOTICE:
    When removing the bolt, keep the nut from rotating.

← COMPONENTSINSTALLATION →