RX400h · Service Manual BODY

INSPECTION

Inspection


INSPECT SEAT MEMORY SWITCH

  1. B068340E01
    Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		 Switch Position
    		 Specified Condition
    1(E) - 2(MMRY)
    		 SET switch ON (pushed)
    		 Below 1 Ω
    1(E) - 2(MMRY)
    		 SET switch OFF (not pushed)
    		 10 kΩ or higher
    1(E) - 4(1)
    		 SW1 switch ON (pushed)
    		 Below 1 Ω
    1(E) - 4(1)
    		 SW1 switch OFF (not pushed)
    		 10 kΩ or higher
    1(E) - 3(2)
    		 SW2 switch ON (pushed)
    		 Below 1 Ω
    1(E) - 3(2)
    		 SW2 switch OFF (not pushed)
    		 10 kΩ or higher

    If the result is not as specified, replace the switch.

← INSTALLATIONINSPECTION →