RX400h · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE FRONT BUMPER STAY CENTER

  1. B115757
    Remove the 5 clips and front bumper stay center.


2. REMOVE FRONT BUMPER ASSEMBLY

  1. B110043
    Using a hexagon 4 mm wrench, remove the hexagon screw.

  1. B115758E01
    Put protective tape under the front fender.

  1. Remove the 6 screws and 2 bolts.

  1. Release the 6 claws and front bumper assembly.

  1. w/ headlight washer:

    1. Remove the washer hose clip.

  1. Disconnect the fog light connectors.


3. REMOVE HEADLIGHT ASSEMBLY

  1. E068306
    Remove the 3 bolts.

  1. E068307
    Pull out the headlight assembly forward, then release the headlight bracket.

  1. E108643E01
    Disconnect each connector and separate the headlight assembly.

  1. Remove the clamp and headlight assembly.


4. REMOVE FRONT NO.2 BUMPER SIDE SUPPORT

  1. E069151
    Using needle nose pliers, release the 2 claws and remove the front No.2 bumper side support from the headlight assembly.

← COMPONENTSDISASSEMBLY →