RX400h · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(Click here)

2. REMOVE FRONT DOOR SCUFF PLATE LH

  1. B111782
    Disengage the 6 claws and 4 clips, and remove the front door scuff plate.

  1. Disconnect the connector. (w/ illumination scuff plate)


3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

  1. B108509
    Remove the 2 clips and the cowl side trim sub-assembly LH.


4. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER (for LHD)

  1. B108510E02
    Using a screwdriver, open the instrument panel finish panel sub-assembly lower cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt <A> and the screw <C>.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the 5 claws and the 4 clips.

  1. Disconnect the connectors and then remove the instrument panel finish panel sub-assembly lower.


5. REMOVE INSTRUMENT PANEL NO.2 UNDER COVER SUB-ASSEMBLY (for RHD)

  1. B108512E02
    Using a screwdriver, push the 3 claws in the direction indicated by the arrow to disengage and remove the guide on the front of the vehicle.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors and remove the instrument panel No.2 under cover sub-assembly.


6. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)

  1. B108513E02
    Remove the 2 bolts <A> and the 2 screws <C>.

  1. Pull the glove compartment door assembly to the rear to remove it.

  1. Disconnect the connector.


7. REMOVE HEADLIGHT SWIVEL ECU (for LHD)

  1. E068367
    Disconnect the connector.

  1. Remove the nut and headlight swivel ECU.


8. REMOVE HEADLIGHT SWIVEL ECU (for RHD)

  1. E068374
    Disconnect the connector.

  1. Remove the bolt and the nut, and headlight swivel ECU.

← COMPONENTSINSTALLATION →