RX400h · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation


1. INSTALL REAR WIPER MOTOR

  1. E068272
    Install the rear wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.


2. INSTALL BACK DOOR TRIM PANEL ASSEMBLY UPPER

3. INSTALL REAR NO.1 WIPER LINK PIVOT WASHER

  1. E108669E01
    Install the rear No.1 wiper link pivot washer with the position mark facing downward as shown in the illustration.


4. INSTALL REAR NO.1 WIPER LINK PIVOT NUT

  1. E108667
    Using a socket wrench 27 mm (1.06 in.), install the rear No.1 wiper link pivot nut.

    NOTICE:
    Be careful not to damage the glass.


5. INSTALL REAR WIPER SHAFT COVER

  1. E108668
    Install the rear wiper shaft cover.


6. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

  1. B108016E03
    Operate the rear wiper and stop the rear wiper motor at the automatic stop position.

  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).

  1. E069047E01
    Install the rear wiper arm and blade assembly with the nut at the position as shown in the illustration.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }


7. INSTALL REAR WIPER ARM COVER

  1. Install the rear wiper arm cover.

  1. Operate the rear wiper while spraying water or washer fluid on the windshield.

  1. Make sure that the wipers function properly and there is no interference with the vehicle body.

← INSPECTIONCOMPONENTS →