RX400h · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE REAR WIPER BLADE ASSEMBLY

  1. E112357E01
    Raise the rear wiper blade assembly to the position as shown in the illustration where the meshing of the claw disengages with a clicking sound.

    NOTICE:
    Be careful not to break the claw.

  1. Pull the rear wiper blade assembly straight away from the rear wiper arm toward the left side of the vehicle.

    NOTICE:
    Do not bend the rear wiper arm with the rear wiper blade removed, as the arm tip could damage the windshield surface.


2. REMOVE REAR WIPER RUBBER

  1. E060704E02
    Pull the end of the rear wiper rubber protruding from the blade stopper as shown in the illustration.

    NOTICE:
    Do not pull out the rear wiper rubber forcibly. Otherwise, the rear wiper rubber backing plates will be deformed or blade claw will be damaged.

    HINT:
    Pushing the rear wiper rubber from the ends towards the middle will allow it to be removed more easily.

← COMPONENTSINSTALLATION →