DISPOSAL

Removal / installation

1. DISPOSE OF BRAKE ACTUATOR ASSEMBLY

1. Using a drill, slowly make a hole at the circumference made by the center points of A and discharge the gas.
   

   CAUTION:

   Be sure to wear protective glasses to protect from fragments that may become airborne due to high pressure.

   HINT:

   1. The hole may be drilled up to approximately 5 to 10 mm ( 0.20 to 0.39 in.) away from the point indicated by A without problem.
      
   2. The gas is nitrogen, which is colorless, odorless, and harmless.