RX400h · Service Manual ENGINE

INSTALLATION

Removal / installation


1. INSTALL ENGINE REAR OIL SEAL

  1. A078769E01
    Apply MP grease to a new oil seal lip.

    NOTICE:
    Keep the lip free from foreign objects.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-15030  
    09950-70010   (09951-07100)

    NOTICE:
    1. Do not tap the oil seal at an angle.
    2. Wipe off extra grease on the crankshaft.


2. INSTALL FLYWHEEL SUB-ASSEMBLY

  1. A109809E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. Clean the bolts and bolt holes.

  1. Apply adhesive to 2 or 3 threads of the bolts.

    Adhesive:
    Part No.08833-00070, THREE BOND 1324 or equivalent

  1. Install the flywheel on the crankshaft.

  1. A108132E01
    Using several steps, install and tighten the 8 bolts uniformly in the sequence shown in the illustration.

    Torque:
    83 N*m{ 846 kgf*cm , 61 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour after installing.


3. INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY

  1. A109809E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A108131
    Install the 6 bolts and transmission input damper.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    HINT:
    Take care not to insert the transmission input damper in the wrong direction.


4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)
← REMOVALCOMPONENTS →