RX400h · Service Manual ENGINE

REMOVAL

Removal / installation


1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)

2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY

  1. A109808E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A108131
    Remove the 6 bolts and transmission input damper from the flywheel.


3. REMOVE FLYWHEEL SUB-ASSEMBLY

  1. A109808E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A108132
    Remove the 8 bolts and flywheel.


4. REMOVE ENGINE REAR OIL SEAL

  1. A078768E01
    Using a knife, cut off the oil seal lip.

  1. Using a screwdriver with the tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check that the crankshaft is not damaged. If it is damaged, smooth the surface with 400-grit sandpaper.

← COMPONENTSINSTALLATION →