RX400h · Service Manual ENGINE

INSTALLATION

Removal / installation


1. INSTALL CRANKSHAFT POSITION SENSOR

  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.

  1. A079763
    Install the crankshaft position sensor with the bolt.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }

  1. Connect the crankshaft position sensor connector.


2. INSTALL FRONT FENDER APRON SEAL RH

  1. A080512
    Install the front fender apron seal RH with the clip and 2 bolts.


3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

  1. A112019E01
    Install the front fender splash shield sub-assembly RH with the screw.


4. INSTALL ENGINE UNDER COVER NO.1

  1. A108722
    Install the 6 bolts, 2 screws, 2 clips and engine under cover.

← INSPECTIONINSPECTION →