RX400h · Service Manual ENGINE

INSTALLATION

Removal / installation


1. INSTALL OXYGEN SENSOR

  1. Temporarily tighten the oxygen sensor to the exhaust pipe sub-assembly front No.3.

    NOTICE:
    Do not to damage the oxygen sensor.

  1. A108665E01
    Using SST, fully tighten the oxygen sensor to the exhaust pipe sub-assembly front No.3.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. A108663
    Connect the oxygen sensor connector and clamp.


2. INSTALL OXYGEN NO.2 SENSOR

  1. Temporarily tighten the oxygen sensor No.2 to the exhaust pipe sub-assembly front.

    NOTICE:
    Do not to damage the oxygen sensor.

  1. A108681E01
    Using SST, fully tighten the oxygen sensor No.2 to the exhaust pipe sub-assembly front.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. A108666
    Connect the oxygen sensor No.2 connector.

← INSPECTIONCOMPONENTS →