RX400h · Service Manual BODY

REMOVAL

Removal / installation


1. REMOVE ROOF DRIP SIDE MOULDING COVER FRONT

  1. B069678
    Using a remover for the moulding cover, disengage the clip and claw, and remove the moulding cover.


2. REMOVE ROOF DRIP SIDE FINISH MOULDING

  1. B069679E01
    Tape the circumference of the moulding for protection.

  1. Using a remover for the roof moulding, release the engagements of the clips and remove the moulding.

    NOTICE:
    1. Do not remove the clips.
    2. In case that the clips are damaged or removed accidentally, replace them with new ones.


3. REMOVE ROOF DRIP SIDE FINISH MOULDING CENTER

  1. B069680E02
    Tape the circumference of the moulding for protection.

  1. Using a remover for the roof moulding, release the engagements of the clips and remove the moulding.


4. REMOVE ROOF DRIP SIDE FINISH MOULDING REAR

  1. B069681E01
    Tape the circumference of the moulding for protection.

  1. Using a remover for the roof moulding, release the engagements of the clips and remove the moulding.

    NOTICE:
    1. Do not remove the clips,
    2. In case that the clips are damages or removed accidentally, replace them with new ones.

← COMPONENTSINSTALLATION →