INSTALLATION
Removal / installation
| 1. INSTALL STEREO COMPONENT AMPLIFIER (w/ Mark Levinson System) |
Install the No.2 amplifier bracket with the 2 bolts.
Install the No.1 amplifier bracket with the 2 bolts.
Connect the 4 connectors.
Install the stereo component amplifier with the 2 bolts and the nut.
| 2. INSTALL STEREO COMPONENT AMPLIFIER (w/o Mark Levinson System) |
Connect the 2 connectors.
Install the stereo component amplifier with the 2 bolts and the nut.
| 3. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY |
Install the rear seat sub floor panel assembly with the 3 bolts and the 3 nuts.
| 4. INSTALL DECK SIDE TRIM BOX LH |
Install the deck side trim box with the 2 clips.
| 5. INSTALL DECK SIDE TRIM BOX RH |
| 6. INSTALL JACK CARRIER ASSEMBLY |
Install the jack carrier assembly, jack assembly and jack carrier support.
| 7. INSTALL REAR FLOOR FINISH PLATE |
Engage the 2 claws and 6 clips, and install the rear floor finish plate.
Install the 2 clips.
| 8. INSTALL NO.3 DECK BOARD SUB-ASSEMBLY |
Install the deck No.3 board sub-assembly with the 2 bolts and 2 nuts.
| 9. INSTALL NO.2 DECK BOARD SUB-ASSEMBLY |
Install the deck No.2 board sub-assembly with the 4 bolts and 2 nuts.
| 10. INSTALL DECK FLOOR BOX REAR |
Install the deck floor box rear with the 2 clips.
| 11. INSTALL DECK FLOOR BOX FRONT |
Install the deck floor box front with the 2 clips.
| 12. INSTALL DECK BOARD SUB-ASSEMBLY |
Install the deck board sub-assembly with the 2 bolt.
Engage the 5 clips.
| 13. INSTALL TONNEAU COVER ASSEMBLY |
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 15. PERFORM INITIALIZATION |
- NOTICE:
- Some systems need initialization when disconnecting the cable from the negative battery terminal. (Click here)