RX400h · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation


1. INSTALL POWER POINT SOCKET COVER

  1. E111294
    Engage the 2 claws and install the power point socket cover.


2. INSTALL POWER POINT SOCKET

  1. E111298E01
    Place the power point socket with the notch on the power point socket cover, and push in the power point socket as hard as possible to install it.


3. INSTALL CONSOLE COVER LOWER

  1. E113056
    Connect the connector.

  1. E113058
    Engage the 3 clips and install the console cover lower with the 2 screws.

  1. E113055
    Engage the clamp.


4. INSTALL REAR CONSOLE BOX

  1. B108546E02
    Connect each of the clamp and the connector.

  1. F045693
    Keeping the rear console box pulled in the rear direction of the vehicle, install the 6 bolts from the left and right sides.

  1. B108545E02
    Connect the console box lock control cable assembly and install the rear console box.


5. INSTALL CONSOLE BOX HOLE COVER

  1. B112173
    Slide the front seat assemblies RH and LH forward.

  1. Slide the rear console box fully to the back end and install the console box hole cover.


6. INSTALL NO.2 CONSOLE BOX HOLE COVER

HINT:
Use the same procedures for the console box No.2 hole cover and the console box hole cover.

← REMOVALCOMPONENTS →