Seat Belt Warning Light for Driver Seat does not Operate
Circuit diagnosis
DESCRIPTION
When turning the ignition switch ON, the combination meter assembly communicates with the supplemental restraint system by the multiplex communication system. Unless the driver side seat belt is fastened, the combination meter assembly will turn on the seat belt warning light for driver side. If the driver side seat belt is fastened, then the combination meter assembly will turn off the driver side seat belt warning light.WIRING DIAGRAM
INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".
- COMBINATION METER:
Item
Test Details
Diagnostic Note
D-BELT REMIND
D-SEAT BELT indicator light (OFF/ON)
-
- OK:
- Switch condition (ON/OFF) can be switched by "ACTIVE TEST".
|
|
||||
| OK | |
 |
| 2. CHECK DTCs |
- HINT:
- Click here
Check DTCs.
| B0120 is output |
B |
| B0120 is not output |
A |
|
|
||||
| A | ||
 |
||
| ||