INSPECTION

Inspection

INSPECT DOOR CONTROL SWITCH

1. Measure the resistance according to the value(s) in the table below.
   

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   2 - 3	Lock	Below 1 Ω
   2 - 3 1 - 2	OFF (Free)	10 kΩ or higher
   1 - 2	Unlock	Below 1 Ω

   HINT:

   If the result is not as specified, replace the switch.

2. Apply battery voltage to the door control switch and check that the switch illuminates.
   

   OK:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 2	Illuminates

   HINT:

   If the result is not as specified, replace the switch.