C1381/97

DESCRIPTION

DTCs C0371/71 can be deleted when the yaw rate and deceleration sensor sends a yaw rate signal or the Test Mode ends. DTCs C0371/71 are output only in the Test Mode.

DTC No.	INF Code	DTC Detecting Condition	Trouble Area
C1381/97	315	Power source voltage is not within specified range when communication between skid control ECU and sensor is valid.	Yaw rate and deceleration sensor circuit Wire harness or connector Skid control ECU

WIRING DIAGRAM

INSPECTION PROCEDURE

1. CHECK HARNESS AND CONNECTOR (BETWEEN YAW RATE AND DECELERATION SENSOR AND IG CIRCUIT)

1. Disconnect the yaw rate and deceleration sensor connector.

2. Turn the ignition switch on.

3. Measure the voltage according to the value(s) in the table below.

   Voltage:

   Tester Connection	Specified Condition
   Y1-5 (IG) - Body ground	10 to 14 V

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2. CHECK HARNESS AND CONNECTOR (BETWEEN YAW RATE AND DECELERATION SENSOR AND BODY GROUND)

1. Disconnect the yaw rate and deceleration sensor connector.

2. Measure the resistance according to the value(s) in the table below.

   Resistance:

   Tester Connection	Specified Condition
   Y1-1 (GND) - Body ground	Below 1 Ω

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
REPLACE YAW RATE AND DECELERATION SENSOR