ON-VEHICLE INSPECTION

Check the operation.

1. Using a speedometer tester, check the speedometer indication according to the table below.
   

   Reference: mph 

   Standard indication	Acceptable range
   20 mph	21.0 to 23.5 mph
   40 mph	42.0 to 44.5 mph
   60 mph	62.5 to 66.0 mph
   80 mph	83.1 to 87.1 mph
   100 mph	103.9 to 108.4 mph
   120 mph	124.7 to 129.6 mph
   140 mph	145.4 to 150.7 mph

   Reference: km/h 

   Standard indication	Acceptable range Data in ( ) is for reference
   20 km/h	(21.0 to 25.0 km/h)
   40 km/h	41.7 to 46.2 km/h
   60 km/h	62.7 to 67.2 km/h
   80 km/h	83.4 to 88.4 km/h
   100 km/h	104.3 to 109.3 km/h
   120 km/h	125.1 to 130.6 km/h
   140 km/h	145.8 to 151.8 km/h
   160 km/h	166.2 to 173.2 km/h
   180 km/h	188.9 to 194.5 km/h
   200 km/h	207.7 to 215.7 km/h
   220 km/h	228.4 to 236.8 km/h
   240 km/h	249.2 to 258.0 km/h

   NOTICE:

   Tire wear, as well as over or under inflation will cause errors.

2. Check the deviation from the acceptable value of the speedometer indication.
   

   Reference:

   Below 0.5 km/h (0.3 mph)
   

Turn the ignition switch to the ON position, then check the position of the receiver gauge needle.

OK:

Needle position is on (EMPTY).

Connect the terminals 2 and 3 on the wire harness side connector of the fuel sender gauge.

Turn the ignition switch to the ON position, then check the position of the receiver gauge needle.

OK:

Needle position is on (FULL).

Disconnect the connector from the sender gauge.

Turn the ignition switch to the ON position, then check the fuel level needle indicates EMPTY and the fuel level warning light comes on.

OK:

Fuel level warning light comes on.

Disconnect the connector from the low oil pressure switch.

Turn the ignition switch to the ON position.

Ground the terminal of the wire harness side connector, then check the low oil pressure warning in the multi-display.

OK:

LOW OIL PRESSURE warning is displayed.

Disconnect the connector from the engine oil level sensor.

Turn the ignition switch to the ON position.

Ground the terminal of the wire harness side connector, then check the low engine oil level warning in the multi-display.

Press the "DISP" button and hold it down.

Turn the ignition switch to the ON position.

OK:

All the dots in the multi-information display come on.

HINT:

This test is also available on "DATA LIST / ACTIVE TEST" (Click here).

Turn the ignition switch off to finish the test mode.