RX400h · Service Manual STEERING

INSTALLATION

Removal / installation


1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU

  1. C111451
    Using a socket wrench (+), install the multiplex tilt and telescopic ECU with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the connectors to the multiplex tilt and telescopic ECU.

    NOTICE:
    1. The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape.
    2. When installing them, connect the connectors of the same color.


2. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY

  1. Temporarily install the steering column upper with switch bracket assembly with 2 new tapered-head bolts.

  1. C111455
    Tighten the 2 tapered-head bolts until the bolt heads break off.


3. INSTALL STEERING COLUMN ASSEMBLY

HINT:
Refer to the instructions for installation of the steering column assembly (power tilt and power telescopic) (Click here).

← REMOVALPRECAUTION →