RX400h · Service Manual STEERING

REMOVAL

Removal / installation


1. SEPARATE CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE ROOM SIDE COVER LH

  1. A108719
    Using a clip remover, remove the engine room side cover.


3. REMOVE INVERTER BRACKET NO.5

  1. C111474
    Remove the bolt and inverter bracket No.5.


4. REMOVE POWER STEERING ECU ASSEMBLY

  1. C108539
    Remove the bolt and ground cable terminal from the power steering ECU assembly.

  1. C108540
    Release the locks of the 2 power steering ECU assembly connectors and disconnect the connectors.

  1. C112234
    Separate the 2 wire harness clamps from the power steering ECU assembly.

  1. C112235
    Remove the 2 bolts and the power steering ECU assembly.

← COMPONENTSINSTALLATION →