REMOVAL
Removal / installation
| 1. REMOVE ENGINE UNDER COVER NO.1 |
Remove the 6 bolts, 2 screws, 2 clips and engine under cover.
| 2. DRAIN HYBRID TRANSAXLE FLUID |
Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.
Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.
Using a socket hexagon wrench 10 mm, install the drain plug, and a new gasket.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
| 3. REMOVE FRONT BUMPER ASSEMBLY |
| 4. REMOVE OIL NO.1 COOLER ASSEMBLY |
Disconnect the 2 oil cooler hoses.
Remove the 3 bolts, and oil cooler assembly.
Remove the 3 bolts and air duct.