RX400h · Service Manual BRAKE

INSPECTION

Inspection


INSPECT REAR SPEED SENSOR

  1. Inspect the rear speed sensor. If any of the following occurs, replace the rear speed sensor with a new one:

    1. The surface of the rear speed sensor is cracked, dented, or chipped off.
    2. The connector is scratched, cracked, or damaged.
    3. The rear speed sensor has been dropped.

  1. F013045E02
    Measure the resistance according to the value(s) in the table below.

    Resistance (at 25 +- 5°C):
    LH 
    Tester Connection
    		 Specified Condition
    1 (RL+) - 2 (RL-)
    		 0.9 to 1.3 kΩ
    RH 
    Tester Connection
    		 Specified Condition
    1 (RR+) - 2 (RR-)
    		 0.9 to 1.3 kΩ

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    LH 
    Tester Connection
    		 Specified Condition
    1 (RL+) - Body ground
    		 1 MΩ or higher
    2 (RL-) - Body ground
    RH 
    Tester Connection
    		 Specified Condition
    1 (RR+) - Body ground
    		 1 MΩ or higher
    2 (RR-) - Body ground

← REMOVALINSTALLATION →