RX400h · Service Manual BRAKE

INSPECTION

Inspection


INSPECT BRAKE PEDAL STROKE SENSOR ASSEMBLY

  1. Inspect the brake pedal stroke sensor assembly. If any of the following occurs, replace with a new brake pedal stroke sensor assembly:

    1. The surface of the brake pedal stroke sensor assembly is cracked, dented, or chipped off.
    2. The connector is scratched, cracked, or damaged.
    3. The brake pedal stroke sensor assembly has been dropped.

  1. F047498E02
    Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		 Specified Condition
    1 (BSR) - 2 (BCSS)
    		 21.45 to 23.15 Ω

← REMOVALINSTALLATION →