PRECAUTIONS

Several precautions must be observed when handling the inflator module to avoid accidental deployment and possible personal injury.

• Never carry the inflator module by the wires or connector on the underside of the module.
• When carrying a live inflator module, hold securely with both hands, and ensure that the bag and trim cover are pointed away.
• Place the inflator module on a bench or other surface with the bag and trim cover facing up.
• With the inflator module on the bench, never place anything on or close to the module which may be thrown in the event of an accidental deployment.
• An air bag is an explosive device. Handle with extreme caution.
• Always disconnect the battery and the air bag connector before removing the steering wheel or beginning work on the air bag system.
• Air bag components must not be repaired or opened. Always use new parts, including the wiring harness.
• Always place a removed air bag unit with the horn pad facing up. Put it in a safe place where it will not be disturbed.
• The air bag unit must not be exposed to grease, fluids, or cleaning agents.
• The air bag unit must not be exposed to temperatures above 194°F (90°C) at any time. Even the heat of a soldering iron can damage or ignite the charge.
• Storage and transport of air bags is subject to rules governing explosive devices and should be done only in the original package.
• Failure to follow proper safety precautions may result in personal injury through accidental firing of the air bag, or through failure of the air bag in an accident.