Measure the clutch pedal height from the face of the pedal pad to the firewall.
Compare the measured value with the proper distance of 6.93–7.17 in.
(176–182mm).
Measure the clutch pedal clevis pin play at the face of the pedal pad. Press
the pedal lightly until resistance is met, and measure this distance. The
clutch pedal clevis pin play should be within 0.04–0.12 in. (1–3mm).
If the clutch pedal height or clevis pin play are not within the standard
values, adjust as follows:
For vehicles without cruise control, turn and adjust the stop bolt so
the pedal height is the standard value, then tighten the locknut.
For vehicles with cruise control, detach the clutch switch connector
and turn the switch to obtain the standard clutch pedal height. Then,
lock by tightening the locknut.
Turn the pushrod to adjust the clutch pedal clevis pin play to agree
with the standard value and secure the pushrod with the locknut.
NOTE: When adjusting the clutch pedal height or the
clutch pedal clevis pin play, be careful not to push the pushrod toward
the master cylinder.
Check that when the clutch pedal is depressed all the way, the interlock
switch switches over from ON to OFF.
