- Tighten the wheel bearing nut to 119 ft. lbs. (162 Nm) while turning the
rotor.
- Loosen the wheel bearing adjusting nut completely.
- Tighten the nut to 18 ft. lbs. (25 Nm), then loosen the nut approximately
30°.
- Using a dial indicator, check the wheel bearing end-play. The specification
is 0.002 in. (0.05mm).
- Install the locknut.
The rear wheel bearings are not adjustable. If the bearings are noisy or become
loose, they must be replaced.
