Axle shaft, Bearing and Seal

REMOVAL & INSTALLATION

Rear

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Remove or disconnect the following:
   • Wheel assembly
   • Brake line
   • Rear brake assembly
   • Parking brake cable and assembly
   • Axle shaft
   • Snapring
   • Retainer
   • Bearing inner race, inner and outer
   • Oil seal
   • Bearing case
   • O-ring
   • Oil seal

   To install:

3. Install or connect the following:
   • Bearing case
   • Bearing inner race, outer. Press the bearing into the bearing case.
   • Oil seal. Press the seal using tools MB990932 and MB990938.
   • Bearing inner race, inner. Press the bearing into the bearing case.
   • Axle shaft, Place into bearing case
   • Retainer, press onto shaft
   • Snapring
   • Oil seal and O-ring into axle shaft
4. Axle shaft assembly into axle.
5. Parking brake cable end
6. Parking brake cable attaching bolt
7. Rear brake assembly
8. Brake line
9. Wheel assembly