[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
13 -FUEL > 13A-DIRECT INJECTION AND MULTIPOINT FUEL INJECTION (DI AND MPI) > TROUBLESHOOTING > DIAGNOSIS CODE PROCEDURES > CODE NO. P0222 THROTTLE POSITION SENSOR (SUB) CIRCUIT LOW INPUT
Code No. P0222: Throttle Position Sensor (sub) Circuit Low Input
 
 
 
 
OPERATION
  • A power voltage of 5 V is applied to the electronic-controlled throttle valve from the engine-ECU connector terminal TPS5.
  • The power voltage is earthed to the engine-ECU connector terminal TPSE from the electronic-controlled throttle valve.
  • The sensor signal is inputted to the engine-ECU connector terminal TPSS from the electronic-controlled throttle valve output terminal.
 
 
FUNCTION
  • The throttle position sensor converts the throttle valve position into voltage and inputs it into the engine-ECU.
  • The engine-ECU controls the throttle valve opening angle.
 
 
TROUBLE JUDGEMENT
Check Condition
  • Ignition switch is "ON" position.
Judgement Criterion
  • Throttle position sensor (sub) output voltage is less than 0.2 V.
 
 
FAIL-SAFE AND BACKUP FUNCTION
  • Throttle opening degree is restricted.
  • Throttle opening degree position is in default position if throttle position sensor (main) fails.
 
 
PROBABLE CAUSES
  • Failed throttle position sensor (sub)
  • Open/short circuit or harness damage in throttle position sensor (sub) circuit or loose connector contact
  • Failed engine-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE data list
  • Data list reference table (Refer to ).
    1. Item 15: Throttle position sensor (sub)
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Go to Step 2.
 
STEP 2. Perform voltage measurement at electronic-controlled throttle valve connector.
  • Disconnect connector, and measure at harness side.
  • Ignition switch: ON
  • Voltage between terminal engine-ECU TPS5 line and body earth.
OK: 4.9 - 5.1 V
Is the check result normal?
Go to Step 5.
Go to Step 3.
 
STEP 3. Check of open circuit, and short circuit in TPS5 line between electronic-controlled throttle valve connector and engine-ECU connector.
Is the check result normal?
Go to Step 4.
Repair the connector(s) or wiring harness.
 
STEP 4. M.U.T.-IIISE data list
  • Data list reference table (Refer to ).
    1. Item 15: Throttle position sensor (sub)
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Replace the engine-ECU.
 
STEP 5. Check of damage in TPS5 line between electronic-controlled throttle valve connector and engine-ECU connector.
Is the check result normal?
Go to Step 6.
Repair the connector(s) or wiring harness.
 
STEP 6. Check of open circuit, short circuit, and damage in TPSS line between electronic-controlled throttle valve connector and engine-ECU connector.
Is the check result normal?
Go to Step 7.
Repair the connector(s) or wiring harness.
 
STEP 7. Replace the electronic-controlled throttle valve
  • After replacing the electronic-controlled throttle valve, reconfirm whether the diagnosis code is set.
Is the diagnosis code set?
Replace the engine-ECU.
Check end.